Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010FOCUS SES, 2D COUPE, STANDARDREPAIR AND DIAGNOSISENGINE MECHANICALMECHANICALENGINE MECHANICAL - 2.0LASSEMBLYENGINEINTAKE MANIFOLD
2010 Ford Focus SES, 2D Coupe, Standard
Intake Manifold
2010 Ford Focus SES, 2D Coupe, StandardSECTION Intake Manifold
ITEM DESCRIPTION
| Item | Part Number | Description |
|---|---|---|
| 1 | 9288 | Fuel supply tube |
| 2 | 8K556 | Coolant outlet |
| 3 | 9D475 | EGR valve |
| 4 | 9E926 | Throttle Body (TB) |
| 5 | 6051 | Cylinder head gasket |
| 6 | 6010 | Cylinder block |
| 7 | 12A699 | Knock Sensor (KS) |
| 8 | 6754 | Oil level indicator and tube |
| 9 | 9424 | Intake manifold |
| 10 | 9439 | Intake manifold gasket |
| 11 | 6049 | Cylinder head |
| 12 | 9F593 | Fuel injector (4 required) |
| 13 | 9H487 | Fuel rail |
NOTE:
Do not loosen or remove the crankshaft pulley bolt without first installing the special tools as instructed in this procedure. The crankshaft pulley and the crankshaft timing sprocket are not keyed to the crankshaft. The crankshaft, the crankshaft sprocket and the pulley are fitted together by friction, using diamond washers between the flange faces on each part. For that reason, the crankshaft sprocket is also unfastened if the pulley bolt is loosened. Before any repair requiring loosening or removal of the crankshaft pulley bolt, the crankshaft and camshafts must be locked in place by the special service tools, otherwise severe engine damage can occur.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.