Electronic Compass: Notes

2010 Ford Focus SES, 2D Coupe, StandardSECTION Notes

The compass signal originates from the compass module, which is integrated into the interior rear view mirror.

The compass display is incorporated into the Front Display Interface Module (FDIM).

The buttons that allow the driver to operate the calibration and zone setting procedures are located in the Front Controls Interface Module (FCIM).

The vehicle heading is displayed as a 1 or 2 character display located in the lower LH side of the FDIMΒ  and indicates the current direction of the vehicle (N, NE, E, SE, S, SW, W, or NW). The compass continuously re-calibrates due to changes in the magnetic field and remains accurate during most driving conditions. The compass display is on with the key in the ON or START position. When the key is first turned to the ON or START position, there is a momentary delay of approximately 6 seconds before the compass display illuminates. If the battery saver has been activated and the key is turned to ON or START, the momentary delay before the compass display illuminates is approximately 3 seconds. The compass display will turn off as soon as the key is turned to the OFF or ACC position.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.