Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010FOCUS S, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 256 (ENGINE SYSTEM)DISASSEMBLYENGINENOTES
2010 Ford Focus S, Standard
Section 256 (Engine System): Disassembly: Engine: Notes
2010 Ford Focus S, StandardSECTION Notes
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL(S) DESCRIPTION
| Remover, Crankshaft Vibration Damper 303-009 (T58P-6316-D) |
|
| Remover, Crankshaft Front Oil Seal 303-107 (T74P-6700-A) |
|
| Lifting Bracket Set, Engine 303-DS086 (D93P-6001-A) |
|
| Compressor, Valve Spring 303-567 (T97P-6565-AH) |
|
| Spacer, Valve Spring Compressor 303-382 (T91P-6565-AH) |
|
| Remover/Installer, Cylinder Head 303-572 (T97T-6000-A) |
|
| Impact Slide Hammer 100-001 (T50T-100-A) |
|
| Remover, Crankshaft Rear Oil Slinger 303-514 (T95P-6701-AH) |
|
| Remover, Crankshaft Rear Oil Seal 303-519 (T95P-6701-EH) |
|
| Installer, Connecting Rod 303-442 (T93P-6136-A) |
|
| Cylinder Ridge Reamer 303-016 (T64L-6011-EA) |
MATERIAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Silicone Gasket Remover ZC-30 | - |
| Motorcraft Metal Surface Prep ZC-31 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.