Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Testing Procedure
2010 Ford Focus S, StandardSECTION Component Testing Procedure
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
SEAT ADJUST SWITCH, DRIVER SIDE FRONT (14A701) - COMPONENT TESTING
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Forward/Rearward circuit | 5 and 4 | Forward | Closed circuit |
| Rest/Rearward | Open circuit | ||
| 5 and 9 | Rest/Forward | Open circuit | |
| Rearward | Closed circuit | ||
| Front up/down circuit | 5 and 2 | Up | Closed circuit |
| Rest/Down | Open circuit | ||
| 5 and 6 | Rest/Up | Open circuit | |
| Down | Closed circuit | ||
| Rear up/down circuit | 5 and 1 | Up | Closed circuit |
| Rest/Down | Open circuit | ||
| 5 and 12 | Rest/Up | Open circuit | |
| Down | Closed circuit | ||
| Forward/Rearward Recliner Circuit | 5 and 8 | Rest/Forward | Open circuit |
| Rearward | Closed circuit | ||
| 5 and 3 | Forward | Closed circuit | |
| Rest/Rearward | Open circuit |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.