Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010FOCUS S, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 144 (ENGINE)SPECIFICATIONSTORQUE SPECIFICATIONS
2010 Ford Focus S, Standard
Torque Specifications
2010 Ford Focus S, StandardSECTION Torque Specifications
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in | ||||
|---|---|---|---|---|---|---|---|
| Accessory drive belt tensioner bolt | 45 | 33 | - | ||||
| Air conditioning compressor bolts and nuts | 25 | 18 | - | ||||
| Air conditioning compressor bracket bolts | 25 | 18 | - | ||||
| Battery B+ nut | 5 | - | 44 | ||||
| Block heater | 14 | 10 | - | ||||
| Camshaft journal cap bolts | 10 | - | 89 | ||||
| Camshaft oil seal retainer bolts | 10 | - | 89 | ||||
| Camshaft position (CMP) sensor bolt | 10 | - | 89 | ||||
| Coolant bypass tube bolts | 10 | - | 89 | ||||
| Coolant pump bolts(1) | - | - | - | ||||
| Crankshaft position (CKP) sensor bolt | 10 | - | 89 | ||||
| Crankshaft damper bolt(1) | - | - | - | ||||
| Crankcase vent cover bolts | 10 | - | 89 | ||||
| Cylinder head bolts(1) | - | - | - | ||||
| Driveshaft bolts | 25 | 18 | - | ||||
| Exhaust gas recirculation (EGR) system module bolts | 25 | 18 | - | ||||
| EGR system module tube nuts | 40 | 30 | - | ||||
| Engine front cover bolts and stud(1) | - | - | - | ||||
| Engine support insulator nuts | 70 | 52 | - | ||||
| Exhaust manifold heat shield bolts | 11 | 8 | - | ||||
| Exhaust manifold nuts | 20 | 15 | - | ||||
| Exhaust manifold stud | 12 | 9 | - | ||||
| Exhaust manifold-to-catalytic converter bolts | 40 | 30 | - | ||||
| Flexplate bolts | 80 | 59 | - | ||||
| Front transaxle stabilizer mount nut and bolt | 40 | 30 | - | ||||
| Fuel rail bolts | 10 | - | 89 | ||||
| Generator bolts and nuts | 48 | 35 | - | ||||
| Generator-to-engine front cover studs | 8 | - | 71 | ||||
| Generator B+ terminal nut (W705790-S901) | 8 | - | 71 | ||||
| Ground strap bolts | 10 | - | 89 | ||||
| Ground cable-to-transaxle housing bolt | 12 | 9 | - | ||||
| Halfshaft support bracket bolts | 48 | 35 | - | ||||
| Ignition coil-on-plug bolts | 6 | - | 53 | ||||
| Intermediate shaft-to-steering gear bolt (N808349-S439) | 23 | 17 | - | ||||
| Knock sensor (KS) bolt | 20 | 15 | - | ||||
| Oil filter adapter bolts(1) | - | - | - | ||||
| Oil filter | 16 | 12 | - | ||||
| Oil level indicator and tube stud bolt | 9 | - | 80 | ||||
| Oil pan baffle nuts(1) | - | - | - | ||||
| Oil pan bolts | 25 | 18 | - | ||||
| Oil pan drain plug | 26 | 19 | - | ||||
| Oil pan-to-transaxle bolts | 40 | 30 | - | ||||
| Oil pressure sender | 14 | 10 | - | ||||
| Oil pump bolts | 10 | - | 89 | ||||
| Oil pump screen and pickup tube bolts | 10 | - | 89 | ||||
| Outer tie-rod end nuts | 90 | 66 | - | ||||
| Power steering fluid reservoir nuts | 9 | - | 80 | ||||
| Power steering fluid reservoir bracket nut | 9 | - | 80 | ||||
| Power steering pump nuts | 25 | 18 | - | ||||
| Power steering pump bracket bolts | 25 | 18 | - | ||||
| Power steering pressure (PSP) tube bracket-to-cylinder head bolts | 7 | - | 62 | ||||
| PSP tube bracket-to-fluid reservoir bracket bolt | 7 | - | 62 | ||||
| PSP tube bracket-to-crossmember bolt | 25 | 18 | - | ||||
| Power steering tube-to-steering gear bolt | 25 | 18 | - | ||||
| Radio ignition interference capacitor bolt | 8 | - | 71 | ||||
| Rear transaxle mount bracket-to- transaxle bolts(2) | 55 | 41 | - | ||||
| RH engine support insulator bracket bolts | 55 | 41 | - | ||||
| RH valve cover-to power steering fluid reservoir stud bolts | 7 | - | 62 | ||||
| Shifter cable bracket bolts | 25 | 18 | - | ||||
| Spark plugs | 15 | 11 | - | ||||
| Stabilizer bar link nuts | 55 | 41 | - | ||||
| Starter motor ground cable bolt | 25 | 18 | - | ||||
| Starter cable positive nut | 12 | 9 | - | ||||
| Thermostat housing-to-coolant pump bolts | 10 | - | 89 | ||||
| Timing chain guide bolts | 25 | 18 | - | ||||
| Timing chain tensioner bolts | 25 | 18 | - | ||||
| Torque converter-to-flexplate nuts | 36 | 27 | - | ||||
| Transaxle-to-engine bolts | 40 | 30 | - | ||||
| Transaxle roll restrictor cross brace-to-body bolts(2) | 55 | 41 | - | ||||
| Transaxle roll restrictor cross brace-to-roll restrictor bolt(2) | 48 | 35 | - | ||||
| Transaxle roll restrictor bracket-to-roll restrictor bolts(2) | 55 | 41 | - | ||||
| Transaxle roll restrictor-to-transaxle bolts(2) | 55 | 41 | - | ||||
| Upper and lower intake manifold bolts | 10 | - | 89 | ||||
| Valve cover bolts and stud bolts | 10 | - | 89 | ||||
| Wiring harness shield-to-valve cover stud bolt nuts | 6 | - | 53 | ||||
|
|||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.