SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010FOCUS S, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1065 (FRONT SUSPENSION SYSTEM)REMOVAL AND INSTALLATIONSTRUT AND SPRING ASSEMBLYINSTALLATION
2010 Ford Focus S, Standard

Strut and Spring Assembly: Installation

2010 Ford Focus S, StandardSECTION Installation
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the strut and spring assembly upper mounting plate into the inner fender.
  2. Align the 4 strut upper bushing nuts to the reference marks.
    • Tighten to 40 Nm (30 lb-ft).
  3. Install the 2 strut-to-knuckle bolts and nuts.
    • Tighten to 115 Nm (85 lb-ft).
  4. Install the upper stabilizer bar link nut.
    • Tighten to 63 Nm (46 lb-ft).
  5. Install the ABS wheel speed sensor harness bolt.
    • Tighten to 15 Nm (11 lb-ft).
  6. Position the brake jounce hose to the bracket and install the brake jounce hose clip.
  7. Check the front end alignment and adjust as necessary. For additional information, refer to SUSPENSION SYSTEM - GENERAL INFORMATION article.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.