SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010FOCUS S, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGPOWER STEERINGSTEERING SYSTEMGENERAL PROCEDURESPOWER STEERING SYSTEM FLUSHINGMATERIAL
2010 Ford Focus S, Standard

Power Steering System Flushing: Material

2010 Ford Focus S, StandardSECTION Material
MATERIAL SPECIFICATIONS CHART

Item Specification
MERCON® V Automatic Transmission Fluid XT-5-QM (or XT-5-QMC) (US); CXT- 5-LM12 (Canada) MERCON® V
NOTE: Do not mix fluid types. Any mixture or any unapproved fluid may lead to seal deterioration and leaks. A leak may ultimately cause loss of fluid, which may result in a loss of power steering assist.
  1. Remove the power steering fluid reservoir cap.
  2. Using a suitable suction device, remove the power steering fluid from the reservoir.
  3. Release the clamp and disconnect the return hose from the reservoir.
    • Remove the clamp from the hose and allow the remaining fluid to drain out of the reservoir.
  4. Plug the power steering fluid reservoir inlet port.
  5. Attach an extension hose to the return hose.
  6. NOTE: Do not reuse the power steering fluid that has been flushed from the power steering system.

    Place the open end of the extension hose into a suitable container.

  7. If equipped with Hydro-Boost®, apply the brake pedal 4 times.
  8. NOTE: Do not overfill the reservoir.

    Fill the reservoir as needed with the specified fluid.

  9. NOTE: Do not allow the power steering pump to run completely dry of power steering fluid. Damage to the power steering pump may occur.

    Start the engine while simultaneously turning the steering wheel to lock and then immediately turn the ignition switch to the OFF position.

  10. NOTE: Avoid turning the steering wheel without the engine running as this may cause air to be pulled into the steering gear.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.