Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010FOCUS S, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGPOWER STEERINGPOWER STEERING SYSTEMSPECIFICATIONSTORQUE SPECIFICATIONS CHART
2010 Ford Focus S, Standard
Torque Specifications Chart
2010 Ford Focus S, StandardSECTION Torque Specifications Chart
TORQUE SPECIFICATIONS CHART
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Accessory drive belt splash shield bolts | 9 | - | 80 |
| Coolant expansion tank bolts | 4 | - | 35 |
| Lower steering column shaft-to-steering gear bolt | 28 | 21 | - |
| Lower subframe bolts | 175 | 129 | - |
| Outer tie-rod end nuts | 35 | 26 | - |
| Power steering fluid reservoir bolts | 25 | 18 | - |
| Power Steering Pressure (PSP) sensor | 20 | - | 177 |
| Power steering pump bolts | 25 | 18 | - |
| Pressure line bracket-to-AC compressor stud nut | 9 | - | 80 |
| Pressure line bracket-to-starter stud nut | 9 | - | 80 |
| Pressure line fitting | 75 | 55 | - |
| Stabilizer bar link upper nuts | 55 | 41 | - |
| Steering gear bolts | 63 | 46 | - |
| Steering line clamp plate bolt | 23 | 17 | - |
| Steering line-to-steering gear bolt | 4 | - | 35 |
| Transaxle roll restrictor bolt | 50 | 37 | - |
| Upper steering column shaft-to-lower steering column shaft bolt | 28 | 21 | - |
| Upper subframe bolts | 103 | 76 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.