Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010F 150 4WD V8-4.6L VIN WREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMKEYTESTING AND INSPECTIONMYKEY(TM) PROGRAMMINGUSING MYKEY(TM) WITH AFTERMARKET REMOTE START SYSTEM
2010 Ford F 150 4WD V8-4.6L VIN W
Using MyKey(TM) with Aftermarket Remote Start System
2010 Ford F 150 4WD V8-4.6L VIN WSECTION Using MyKey(TM) with Aftermarket Remote Start System
MyKey(TM) Programming
Using MyKey(TM) with Aftermarket Remote Start System
Program Remote Start System as a MyKey(TM)
NOTE: The # MYKEY(S) PROGRAMMED or the # ADMIN KEYS PROGRAMMED messages that may be displayed in the message center includes the remote start system as an additional key in the total count, depending on whether or not it was programmed as a MyKey(TM). Refer to the Check MyKey(TM) System Status to determine if this is the case. Check MyKey(TM) System Status
NOTE: The MyKey(TM) system is not compatible with non Ford approved aftermarket remote start systems. If a Ford approved remote start system is installed on the vehicle and it is started using the remote start, the vehicle stalls if a door is opened or if the vehicle is shifted into gear. The driver must insert their key into the ignition lock cylinder, cycle the ignition to the ON position and drive the vehicle with the MyKey(TM) restrictions that are programmed into their MyKey(TM). If the remote start system is a non-Ford approved system, the vehicle may not stall when a door is opened or the vehicle is shifted into gear. If the remote start system has not been programmed as a MyKey(TM) and the driver is a MyKey(TM) driver, the driver could possibly drive the vehicle using the remote start system as an admin key with no MyKey(TM) restrictions. To resolve this incompatibility, it is necessary to either recycle the MyKey(TM) before the vehicle is driven or program the non-Ford approved remote start system as a MyKey(TM).
1. Enter the vehicle and close all doors.
2. Remote start the vehicle using a remote start fob.
3. Follow the steps of the Program a MyKey(TM) procedure.
Disable MyKey(TM) with the Remote Start System
NOTE: It is possible to program all of the keys as MyKeys(TM), with the remote start system being the only admin key. This procedure disables MyKey(TM) in the event of the aftermarket remote start system being programmed as the only admin key.
1. Enter the vehicle and close all doors.
2. Remote start the vehicle using the remote start fob.
3. Follow the steps of the Disable MyKey(TM) procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.