Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Ford Explorer 4.6 8, AWDFACTORY OEM SERVICE PROCEDURE
DTC Index
- Air Bag Supplement Restraint Systems DTCS
- Anti-Lock & Vehicle Dynamic Brake Systems DTCS
- Anti-Theft - Passive Anti-Theft System (Pats) DTCS
- Climate Control System (HVAC) DTCS
- Cruise Control (Speed Control) Systems DTCS
- Engine Cooling DTCS
- Exterior Lighting
- Four-Wheel Drive (4WD) Systems
- Fuel System - General Information DTCS
- Handles, Locks, Latches And Entry Systems DTCS
- Horn DTCS
- Information And Entertainment Systems
- Audio Control Module (ACM) - With Navigation DTC Chart
- Audio Control Module (ACM) - Without Navigation DTC Chart
- Satellite Digital Audio Receiver System (SDARS) Module DTC Chart
- Rear Entertainment Module (RETM) DTC Chart
- Accessory Protocol Interface Module (APIM) DTC Chart
- Global Positioning System Module (GPSM) DTC Chart
- Instrument Cluster And Panel Illumination
- Instrument Cluster (Ic), Message Center, And Warning Chimes DTCS
- Interior Lighting
- Module Communications Network DTCS
- Parking Aid DTCS
- Power Running Board (PRB) MODUL DTCS
- Powertrain DTCS
- Power Windows DTCS
- Starting System DTCS
- Steering Column Switches DTCS
- Transmissions DTCS
- Wheels & Tires - Tire Pressure Monitoring System (TPMS) DTCS
- Wiper/Washer System DTCS
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
