Audio Control Module (ACM)

2010 Ford Escape 2WD V6-3.0LSECTION Audio Control Module (ACM)



Audio Control Module (ACM)

Without Navigation









With Navigation









Removal and Installation

All vehicles

1. NOTE: Module configuration is only required if a new ACM is being installed.

Upload the ACM configuration to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Information Bus. Programming and Relearning

2. Remove the middle instrument panel center finish panel. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.

3. Remove the 4 ACM screws.
- To install, tighten to 2 Nm (18 lb-in) (navigation).

- To install, tighten to 1 Nm (9 lb-in) (all except navigation).

Navigation

4. Disconnect the antenna and electrical connectors.

All except navigation

5. NOTE: Only carry out this step if installing a new ACM.

Remove the 2 ACM brackets.

All vehicles

6. Remove the ACM.

7. To install, reverse the removal procedure.
- Download the configuration information to the ACM. For additional information, refer to PMI in Information Bus. Programming and Relearning

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.