Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Instrument Panel Finish Panel - Center, Middle
2010 Ford Escape 2WD V6-3.0LSECTION Instrument Panel Finish Panel - Center, Middle
Instrument Panel Finish Panel - Center, Middle
Removal and Installation
1. Remove the upper instrument panel center finish panel. For additional information, refer to Instrument Panel Finish Panel - Center, Upper Instrument Panel Finish Panel - Center, Upper.
2. Remove the lower instrument panel center finish panel. For additional information, refer to Instrument Panel Finish Panel - Center, Lower Instrument Panel Finish Panel - Center, Lower.
3. Remove the 4 middle instrument panel center finish panel screws.
4. Remove the middle instrument panel center finish panel in the following sequence.
1. Pull outward to release the retaining clips.
2. Disconnect the electrical connectors.
5. To install, reverse the removal procedure.
- Make sure to align the trim panel retaining clips to the retaining clip holes in the instrument panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.