Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010ESCAPE 2WD V6-3.0LREPAIR AND DIAGNOSISBODY AND FRAMESEATSSERVICE AND REPAIRLUMBAR ASSEMBLY
2010 Ford Escape 2WD V6-3.0L
Lumbar Assembly
2010 Ford Escape 2WD V6-3.0LSECTION Lumbar Assembly
Lumbar Assembly
Removal and Installation
NOTE: For component identification and locations, refer to Seat - Exploded View, Front Seat - Exploded View, Front.
1. Remove the backrest cover. For additional information, refer to Seat Backrest Cover - Front Seat Backrest Cover - Front.
2. Remove the backrest foam pad.
3. Remove the 2 screws and position aside the lumbar adjuster.
4. Detach the lumbar assembly from the backrest frame wires and remove.
5. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.