Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2010EDGE FWD V6-3.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSTURN SIGNALSSERVICE AND REPAIR
2010 Ford Edge FWD V6-3.5L
Turn Signals: Service and Repair
2010 Ford Edge FWD V6-3.5LSECTION Service and Repair
Rear Lamp Assembly
NOTE: Edge shown, MKX similar.
Removal and Installation
1. NOTE: The rear lamp assembly is held in place by snap-type retainers. The lamp should be pulled straight and rearward to remove.
Remove the 2 screws and the rear lamp assembly.
- Disconnect the electrical connectors.
2. To install, reverse the removal procedure.
- An audible click should be heard when the rear lamp assembly is fully seated to the quarter panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.