Engine Ignition Components - Exploded View

2009 Ford Ranger 2D Pickup, 2.3 D, AutomaticSECTION Engine Ignition Components - Exploded View
WARNING: This page is about a different variant/trim than selected.

Ignition System Components 

Fig 1: Exploded View Of Engine Ignition Components With Torque Specifications
G06182026Courtesy of FORD MOTOR CO.
ITEM DESCRIPTION CHART

Item Part Number Description
1 12286 Spark plug wire (6 required)
2 12405 Spark plug (6 required)
3 14A464 Ignition coil electrical connector (part of 12B637)
4 W706216 Ignition coil bolt (4 required)
5 18801 Radio ignition interference capacitor
6 12029 Ignition coil

RH Splash Shield 

Fig 2: Identifying RH Splash Shield
G06181625Courtesy of FORD MOTOR CO.
ITEM DESCRIPTION CHART

Item Part Number Description
1 - RH splash shield pushpin (5 required)
2 16034 RH splash shield
  1. For additional information, refer to the appropriate procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.