Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009RANGER 2D PICKUP, 2.3 D, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 306 (STEERING COLUMN)SPECIFICATIONSTORQUE SPECIFICATIONS
2009 Ford Ranger 2D Pickup, 2.3 D, Automatic
Torque Specifications
2009 Ford Ranger 2D Pickup, 2.3 D, AutomaticSECTION Torque Specifications
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Clockspring mounting bracket screws | 8 | - | 71 |
| Gearshift lever screw (column shift vehicles) | 18 | 13 | - |
| Ignition switch screw | 5 | - | 44 |
| Inhibitor cable bracket bolts (floor shift vehicles) | 6 | - | 53 |
| Lower steering column shaft-to-steering gear bolt | 30 | 22 | - |
| Lower steering column shroud screws | 2 | - | 18 |
| Shift cable bracket bolts (column shift vehicles) | 9 | - | 80 |
| Shift lever screw | 18 | 13 | - |
| Steering column nuts | 30 | 22 | - |
| Steering wheel bolt | 40 | 30 | - |
| Transmission range indicator screw | 5 | - | 44 |
| Upper steering column shaft bearing nuts | 11 | 8 | - |
| Upper steering column shaft-to-lower steering column shaft bolt | 48 | 35 | - |
| Upper steering column shaft-to-steering column bolt | 30 | 22 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.