Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009RANGER 2D PICKUP, 2.3 D, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 300 (FUEL CHARGING SYSTEM & FUEL CONTROL SYSTEM)REMOVAL AND INSTALLATIONTHROTTLE BODYINSTALLATION
2009 Ford Ranger 2D Pickup, 2.3 D, Automatic
Throttle Body: Installation
2009 Ford Ranger 2D Pickup, 2.3 D, AutomaticSECTION Installation
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
- Using a new gasket, install the TB and the 4 bolts.
- Tighten the bolts in 2 stages.
- Stage 1: Tighten to 9 Nm (80 lb-in).
- Stage 2: Rotate an additional 90 degrees.
- Tighten the bolts in 2 stages.
- Connect the electronic throttle control and the TP sensor electrical connectors.
- Install the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.