Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009RANGER 2D PICKUP, 2.3 D, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 241 (FUEL SYSTEM - GENERAL INFORMATION)DESCRIPTION AND OPERATIONFUEL SYSTEM
2009 Ford Ranger 2D Pickup, 2.3 D, Automatic
Fuel System
2009 Ford Ranger 2D Pickup, 2.3 D, AutomaticSECTION Fuel System
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
The fuel system consists of the:
- fuel filter.
- fuel injectors.
- Fuel Pump (FP) module.
- fuel level sensor.
- fuel rail.
- fuel rail pressure and temperature sensor.
- saddle-type fuel tank.
- fuel tank filler cap.
- fuel tank filler pipe.
- Fuel Tank Pressure (FTP) sensor (part of the fuel vapor tube assembly).
- fuel tubes (liquid and vapor).
- Inertia Fuel Shutoff (IFS) switch.
The vehicle:
- utilizes an Electronic Returnless Fuel System (ERFS).
- has a saddle-type fuel tank FP module has a fuel level sensor.
- has a FP module that supplies fuel under pressure to the fuel rail.
- is equipped with a sequential Multi-Port Fuel Injection (MFI) system.
- has fuel tubes (liquid and vapor) mounted on the underside of the vehicle in a bundle.
- has a Fuel Tank Pressure (FTP) sensor (part of the fuel vapor tube assembly).
- uses separately controlled fuel injectors for each cylinder. The fuel injectors are mounted to the intake manifold.
- fuel injectors are supplied with pressurized fuel from the FP module to the fuel rail.
- has a fuel rail which is equipped with a fuel rail pressure and temperature sensor.
- fuel injection rail pressure is controlled by the electronic FP module which is enabled by the PCM.
- has a one-fourth turn vented type fuel tank filler cap.
- has a fuel tank filler pipe assembly, which cannot be modified in any way and is serviced only by installation of a new fuel tank filler pipe assembly.
- has an IFS switch located in the driver side footwell that shuts off fuel in the event of a collision.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.