Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009RANGER 2D PICKUP, 2.3 D, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 221 (CONVERTIBLE TOP SYSTEM)SPECIFICATIONSTORQUE SPECIFICATIONS
2009 Ford Ranger 2D Pickup, 2.3 D, Automatic
Torque Specifications
2009 Ford Ranger 2D Pickup, 2.3 D, AutomaticSECTION Torque Specifications
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Clevis-to-hydraulic lift cylinder rod bolts | 20 | - | 177 |
| Compression panel screws | 2 | - | 18 |
| Convertible top ajar switch screw | 9 | - | 80 |
| Convertible top frame No. 5 bow pivot bolts | 9 | - | 80 |
| Convertible top latch screws | 6 | - | 53 |
| Header form panel screws | 5 | - | 44 |
| Hydraulic fluid reservoir fill plug | 1 | - | 9 |
| Hydraulic lift cylinder bracket bolts | 20 | - | 177 |
| Hydraulic line-to-motor bolts | 14 | - | 124 |
| Hydraulic pump and motor assembly nuts | 4 | - | 35 |
| L-bracket bolts | 27 | 20 | - |
| Pivot bracket bolts | 48 | 35 | - |
| Pivot bracket-to-quarter panel bracket bolts | 11 | - | 97 |
| Weatherstrip retaining channel screws | 6 | - | 53 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.