Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009RANGER 2D PICKUP, 2.3 D, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 20 (HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS)SPECIFICATIONSTORQUE SPECIFICATIONS
2009 Ford Ranger 2D Pickup, 2.3 D, Automatic
Torque Specifications
2009 Ford Ranger 2D Pickup, 2.3 D, AutomaticSECTION Torque Specifications
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Door latch bolts (double latch) | 12 | 9 | - |
| Door latch screws (single latch) | 12 | 9 | - |
| Front door interior door handle trim panel screw | 2 | - | 18 |
| Front door latch screws | 12 | 9 | - |
| Hood latch bolts | 12 | 9 | - |
| Exterior sliding door handle nuts | 12 | 9 | - |
| Sliding door remote control bolts (inner) | 12 | 9 | - |
| Sliding door remote control bolts (front) | 10 | - | 89 |
| Lower sliding door latch bolt | 12 | 9 | - |
| Lower sliding door latch nut | 12 | 9 | - |
| Rear sliding door latch bolts | 12 | 9 | - |
| Sliding door rear latch cable adjusting bolt | 10 | - | 89 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.