Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009RANGER 2D PICKUP, 2.3 D, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 180 (DRIVELINE SYSTEM - GENERAL INFORMATION)GENERAL PROCEDURESDRIVELINE ANGLE MEASUREMENT
2009 Ford Ranger 2D Pickup, 2.3 D, Automatic
Driveline Angle Measurement
2009 Ford Ranger 2D Pickup, 2.3 D, AutomaticSECTION Driveline Angle Measurement
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Anglemaster II Driveline Inclinometer/Protractor | 164-R2402 or equivalent |
NOTE:
This procedure does not apply to CV joints, flex couplers or double cardan joints that are used in some driveshaft. This check is for single-cross and roller-style joints found in the driveshaft.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.