Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009RANGER 2D PICKUP, 2.3 D, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 173 (COMPONENT TESTING)COMPONENT TESTINGIGNITION SWITCHCOMPONENT TESTING PROCEDURE
2009 Ford Ranger 2D Pickup, 2.3 D, Automatic
Component testing procedure
2009 Ford Ranger 2D Pickup, 2.3 D, AutomaticSECTION Component testing procedure
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT TESTING PROCEDURE
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Run power circuit | 8 and 3 8 and 6 8 and 7 |
Lock | Open circuit |
| Accessory | Open circuit | ||
| Run | Closed circuit | ||
| Start | Open circuit | ||
| Run/Start power circuit | 8 and 3 9 and 1 |
Lock | Open circuit |
| Accessory | Open circuit | ||
| Run | Closed circuit | ||
| Start | Closed circuit | ||
| Run/Acc power circuit | 8 and 3 9 and 5 |
Lock | Open circuit |
| Accessory | Closed circuit | ||
| Run | Closed circuit | ||
| Start | Open circuit | ||
| Start power circuit | 8 and 3 9 and 10 |
Lock | Open circuit |
| Accessory | Open circuit | ||
| Run | Open circuit | ||
| Start | Closed circuit | ||
| Key-in-igntion | 8 and 3 | Key out of ignition | Open circuit |
| Key in ignition | Closed circuit |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.