Section 171 (Electrical Component Locator): Grounds

2009 Ford Ranger 2D Pickup, 2.3 D, AutomaticSECTION Grounds
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
GROUNDS LOCATION

Component Location
G100 Front of right fender. See Figure.
G101 Right front of engine. See Figure.
G102 Front of left fender. See Figure.
G103 Front of left fender. See Figure.
G106 Left rear of engine compartment. See Figure.
G107 Left rear of engine compartment. See Figure.
G108 Front of right fender. See Figure.
G109 Front of right fender. See Figure.
G200 Right kick panel. See Figure.
G201 Right kick panel. See Figure.
G202 Right kick panel. See Figure.
G203 Right kick panel. See Figure.
G204 Right kick panel. See Figure.
G212 Behind left kick panel. See Figure.
G213 Behind left kick panel. See Figure.
G215 Right kick panel. See Figure.
G220 Right kick panel. See Figure.
G403 Right rear seat. See Figure.
G405 Bottom center of rear seat. See Figure.
G406 Bottom center of rear seat. See Figure.
G407 Behind left rear seat. See Figure.
G408 Behind left rear seat. See Figure.
G410 Center rear of luggage compartment. See Figure.
G411 Center front of luggage compartment. See Figure.
G420 Right "C" pillar. See Figure.
G425 Center front of luggage compartment. See Figure.
G450 Right rear seat. See Figure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.