Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009RANGER 2D PICKUP, 2.3 D, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 139 (ELECTRONIC ENGINE CONTROL SYSTEM)REMOVAL & INSTALLATIONPOWERTRAIN CONTROL MODULE (PCM)INSTALLATION
2009 Ford Ranger 2D Pickup, 2.3 D, Automatic
Powertrain Control Module (PCM): Installation
2009 Ford Ranger 2D Pickup, 2.3 D, AutomaticSECTION Installation
WARNING: This page is about a different car, the 2008 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Install the PCM and the 2 nuts.
- Tighten to 10 Nm (89 lb-in).
- Connect the 3 PCM electrical connectors.
- Position the ground wire terminals and install the stud bolt.
- Tighten to 10 Nm (89 lb-in).
- Install the PCM wiring harness retainer nut.
- Tighten to 10 Nm (89 lb-in).
- Restore the module configurations for the instrument cluster module and the PCM. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION article.
NOTE:
If a new PCM is installed, the parameters must be reset in both the PCM and the instrument cluster module or the vehicle will experience a PATS no-start. This will occur even if the vehicle is not equipped with PATS. PATS vehicles and non-PATS vehicles have parameters in the instrument cluster module and the PCM and they both must be reset whenever a new PCM is installed. For additional information on PATS, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS)
article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.