Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009RANGER 2D PICKUP, 2.3 D, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSEXTERIOR LIGHTING SYSTEMDIAGNOSIS AND TESTINGDIAGNOSTIC TROUBLE CODE (DTC) CHART
2009 Ford Ranger 2D Pickup, 2.3 D, Automatic
Diagnostic Trouble Code (DTC) Chart
2009 Ford Ranger 2D Pickup, 2.3 D, AutomaticSECTION Diagnostic Trouble Code (DTC) Chart
SMART JUNCTION BOX (SJB) DTC CHART
| DTC | Description | Action |
|---|---|---|
| B1470 | Lamp Headlamp Input Circuit Failure | Go To PINPOINT TEST E . |
| B1569 | Lamp Headlamp High-Beam Circuit Short to Battery | Go To PINPOINT TEST E . |
| B2030 | Front Fog Lamp Relay Ckt Failure | If the fog lamps are inoperative, Go To PINPOINT TEST N . If the fog lamps are always on, Go To PINPOINT TEST P . |
| B2261 | Park Lamp Switch Failure | Go To PINPOINT TEST M . |
| B2472 | Fog Lamp Switch Failure | Go To PINPOINT TEST P . |
| B2512 | Front Fog Lamp Relay Ckt Short to Battery | Go To PINPOINT TEST N . |
| B2973 | Daytime Running Lamps Output Shorted to Ground | Go To PINPOINT TEST W . |
| U0155 | Lost Communication With Instrument Panel Cluster IC Control Module | Go To PINPOINT TEST X . |
| All other DTCs | - | REFER to MULTIFUNCTION ELECTRONIC MODULES . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.