SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009RV CUTAWAY 6.8 SREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 29 (MODULE CONFIGURATION SYSTEM)DIAGNOSTIC TESTSMODULE CONFIGURATIONPRINCIPLES OF OPERATIONDEFINITION OF TERMSAS-BUILT DATA
2009 Ford RV Cutaway 6.8 S

As-Built Data

2009 Ford RV Cutaway 6.8 SSECTION As-Built Data
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

As-Built data is a VIN specific module configuration record. During vehicle build, the configuration from all modules is downloaded and stored in the As-Built database. As-Built data will not reflect customer preference items that have been changed from the default state. These items will need to be changed using programmable parameters after the module is configured.

NOTE: It is not necessary to obtain As-Built data unless directed to do so by the scan tool. This data may be accessed from the technician service publication website.

The following chart lists body/chassis module As-Built data addresses:

BODY/CHASSIS MODULE ADDRESSES FOR AS-BUILT ENTRY

Module Name Module Address
Audio control module (ACM) 727
Instrument cluster (IC) 720
Satellite digital audio receiver system (SDARS) module 782
Smart junction box (SJB) 726

The following chart describes specific module programming information:

MODULE CONFIGURATION AND PARAMETER INDEX

Module Name Reprogram/ Flash Capable Requires PMI Requires Adaptive Learning Requires Calibration Available Programmable Parameters
ABS module No No No No
  • None
Audio control module (ACM) Yes Yes No No
  • Language E/F/S (NAV only)
  • Display units English/metric (NAV only)
Instrument cluster (IC) Yes Yes No No
  • None
PCM Yes Yes Yes No
  • Speed control enable/disable
  • Tire size
  • Axle ratio
Restraints control module (RCM) No No No
  • Seat weight sensor re-zero
  • None
Satellite digital audio receiver system (SDARS) module No Yes No No
  • None
Smart junction box (SJB) Yes Yes No No
  • None
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.