Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009RV CUTAWAY 6.8 SREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2 (COMPONENT TESTING)COMPONENT TESTINGMULTIFUNCTION SWITCHCOMPONENT TESTING PROCEDURE
2009 Ford RV Cutaway 6.8 S
Component testing procedure
2009 Ford RV Cutaway 6.8 SSECTION Component testing procedure
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT TESTING PROCEDURE
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Turn signal | 6 and 10 | Left turn | Closed circuit |
| 7 and 10 | Right turn | Closed circuit | |
| Flash-to-pass | 8 and 10 | Pull and hold lever stalk toward steering wheel | Open circuit |
| 9 and 10 | Closed circuit | ||
| High beam/Low beam | 8 and 10 | Lever stalk in detent toward steering wheel | Closed circuit |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.