SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009RV CUTAWAY 6.8 SREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID)DTC DIAGNOSISDTC P0480: - FAN 1 CONTROL CIRCUIT
2009 Ford RV Cutaway 6.8 S

DTC P0480: - Fan 1 Control Circuit

2009 Ford RV Cutaway 6.8 SSECTION DTC P0480: - Fan 1 Control Circuit
DTC P0480: - FAN 1 CONTROL CIRCUIT

For Relay Controlled Electric Cooling Fan 
Description:  Monitors the low fan control (LFC) primary circuit output from the powertrain control module (PCM). The test fails when the PCM grounds the LFC circuit and excessive current draw is detected on the LFC circuit; or with the LFC circuit not grounded by the PCM the voltage is not detected on the LFC circuit (the PCM expects to detect VPWR voltage coming through the low speed fan control relay coil to the LFC circuit).
Possible Causes: 
  • Open or short LFC circuit
  • Open VPWR circuit to the low speed FC relay
  • Damaged low speed FC relay
Diagnostic Aids:  When the LFC PID reads YES, a concern is currently present. During the key on engine off (KOEO) self-test, the cooling fan is cycled on and off. A short to voltage can only be detected when the PCM is grounding the LFC circuit. During the KOEO and key on engine running (KOER) self-test, the LFC circuit is cycled on and off.
For Variable Speed Electric Cooling Fan 
Description:  This test checks the fan control variable (FCV) output circuit. The DTC sets if the powertrain control module (PCM) detects the voltage on the FCV circuit is not within the expected range.
Possible Causes: 
  • FCV circuit open or short
  • B+ or ground circuit concern to cooling fan
  • VPWR open to cooling fan (if applicable)
  • Damaged cooling fan module
Diagnostic Aids:  During the key on engine off (KOEO) self-test, the cooling fan is cycled on and off.
For Cooling Fan Clutch 
Description:  This test checks the fan control variable (FCV) output circuit for the cooling fan clutch. The DTC sets if the powertrain control module (PCM) detects the voltage on the FCV circuit is not within the expected range.
Possible Causes: 
  • FCV circuit open in the harness
  • FCV circuit short to voltage or ground in the harness
  • Damaged cooling fan clutch solenoid.
Diagnostic Aids:  During the key on engine off (KOEO) self-test, the cooling fan is cycled on and off.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
Escape/Mariner,
Focus,
Mustang,
Ranger 2.3L		 GO to Pinpoint Test KF .
Crown Victoria,
Edge,
Flex,
Fusion,
Milan,
MKS,
MKX,
MKZ,
Sable,
Taurus,
Taurus X,
Town Car		 GO to Pinpoint Test KN .
Expedition,
Navigator,
Mountaineer,
F-150,
Explorer,
Explorer Sport
Trac		 GO to Pinpoint Test HV .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.