Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009PICKUP F350 SUPER DUTY, 2D PICKUP, 6.8 Y, RWD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID)DTC DIAGNOSISDTC P1516: - INTAKE MANIFOLD RUNNER CONTROL (IMRC) INPUT ERROR (BANK 1)
2009 Ford Pickup F350 Super Duty, 2D Pickup, 6.8 Y, RWD, Standard
DTC P1516: - Intake Manifold Runner Control (IMRC) Input Error (Bank 1)
2009 Ford Pickup F350 Super Duty, 2D Pickup, 6.8 Y, RWD, StandardSECTION DTC P1516: - Intake Manifold Runner Control (IMRC) Input Error (Bank 1)
DTC P1516: - INTAKE MANIFOLD RUNNER CONTROL (IMRC) INPUT ERROR (BANK 1)
| Description: | The IMRC system is monitored for failure during continuous or key on engine off (KOEO) self-test. Each DTC distinguishes the corresponding bank for IMRC actuator assemblies with dual monitor switches. The test fails when the signal is outside an expected calibrated range. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Monitor the IMRC and IMRCM PIDs. The IMRCM state should change when the IMRC is commanded open or closed. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to Pinpoint Test HU . | - | GO to Pinpoint Test HU . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.