Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009PICKUP F350 SUPER DUTY, 2D PICKUP, 6.8 Y, 4WD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX -- F150ANTI-THEFT SYSTEMS (PATS) DTCSPCM DTC CHART
2009 Ford Pickup F350 Super Duty, 2D Pickup, 6.8 Y, 4WD, Standard
PCM DTC Chart
2009 Ford Pickup F350 Super Duty, 2D Pickup, 6.8 Y, 4WD, StandardSECTION PCM DTC Chart
PCM DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| P1260 | Theft Detected, Vehicle Immobilized | If there are any PATS DTCs present in the IC , ADDRESS them first. This DTC may indicate a Controller Area Network (CAN) concern or a parameter reset concern. MAKE SURE to verify if there are any communication concerns/DTCs with any modules. REFER to MODULE COMMUNICATIONS NETWORK . If DTC P1260 is the only DTC present, there may be a power or ground concern with the PCM. REFER to the INTRODUCTION - GASOLINE MODELS . |
| P1602 | Immobilizer/ECM Communication Error |
NOTE:
If IC
DTC U2510 is also present, address IC
DTC U2510 first. Go To PINPOINT TEST G
. |
| P1622 | Immobilizer ID Does Not Match | CARRY OUT a parameter reset of the IC and the PCM and CYCLE the ignition 3-5 times, making an attempt to start the vehicle each key cycle. REFER to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET . CLEAR the DTCs. CYCLE the ignition. REPEAT the self-test. |
| All other DTCs | - | REFER to the INTRODUCTION - GASOLINE MODELS . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.