Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Ford Mustang V8-5.4L SCFACTORY OEM SERVICE PROCEDURE
Transmission Position Sensor/Switch: Adjustments
5R55S
Transmission Range (TR) Sensor Adjustment
Adjust
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the selector lever cable from the manual control lever.
3. Loosen the Transmission Range (TR) sensor screws.
4. NOTICE: Tightening one screw before tightening the other may cause the sensor to bind or become damaged.
NOTE: The manual control lever must be in the NEUTRAL position.
Using the TR Sensor Alignment Gauge, align the TR sensor and tighten the screws in an alternating sequence.
- Tighten to 8 Nm (71 lb-in).
5. Install the selector lever cable to the manual control lever.
6. Verify that the selector lever cable is adjusted correctly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.