Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009MUSTANG SHELBY GT500, 2D CONVERTIBLEREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSINTERIOR LIGHTING SYSTEM
2009 Ford Mustang Shelby GT500, 2D Convertible
Interior Lighting System
2009 Ford Mustang Shelby GT500, 2D ConvertibleSECTION Interior Lighting System
- Description And Operation
- Diagnostic Tests
- Interior Lighting
- Notes
- Principles of Operation
- Inspection and Verification
- DTC Charts
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A: The Courtesy Lamps Are Inoperative
- Pinpoint Test B: The Courtesy Lamps Do Not Turn On With One Door Open
- Pinpoint Test C: The Courtesy Lamps Are Inoperative - Using The Dimmer Switch
- Pinpoint Test D: The Courtesy Lamps Stay On Continuously
- Pinpoint Test E: The Demand Lamps Are Inoperative
- Pinpoint Test F: The Luggage Compartment Lamp Is Inoperative
- Pinpoint Test G: The Luggage Compartment Lamp Stays On Continuously
- Pinpoint Test H: The Battery Saver Does Not Deactivate After Timeout
- Pinpoint Test I: The Ambient Lighting Is Inoperative
- Pinpoint Test J: The Ambient Lighting Does Not Operate Correctly - Does Not Cycle Through Color Variations
- Interior Lighting
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.