Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 8 (ELECTRONIC ENGINE CONTROL - 2.3)REMOVAL AND INSTALLATIONCLUTCH PEDAL POSITION (CPP) SWITCH

2009 Ford Fusion SEL, 3.0 1, FWD

Clutch Pedal Position (CPP) Switch

2009 Ford Fusion SEL, 3.0 1, FWDSECTION Clutch Pedal Position (CPP) Switch

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Clutch Pedal Position (CPP) Switch

Courtesy of FORD MOTOR CO.

Item	Part Number	Description
1	-	Clutch Pedal Position (CPP) switch electrical connector (part of 14290)
2	7C534	CPP

Disconnect the Clutch Pedal Position (CPP) switch electrical connector.
Rotate the CPP switch clockwise and remove the CPP switch.
To install, reverse the removal procedure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.