Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 965 (ANTI-LOCK BRAKE SYSTEM)
2009 Ford Fusion SEL, 3.0 1, FWD
Section 965 (Anti-Lock Brake System)
2009 Ford Fusion SEL, 3.0 1, FWDSECTION Section 965 (Anti-Lock Brake System)
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Diagnostic Tests
- Anti-Lock Control
- Notes
- Principles of Operation
- Inspection and Verification
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A: DTC B1676 - Battery Pack Voltage Out of Range
- Pinpoint Test B: DTC C1095 - ABS Hydraulic Pump Motor Circuit Failure
- Pinpoint Test C: DTCs C1145, C1155, C1165 and C1175 - Wheel Speed Sensor Input Circuit Failure
- Pinpoint Test D: DTCs C1233, C1234, C1235 and C1236 - Wheel Speed Sensor Input Signal Missing
- Anti-Lock Control - Hybrid
- Notes
- Principles of Operation
- Inspection and Verification
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test E: DTCs U2060 and U2062 - ECU Redundant Power Circuit or Ground Circuit Open
- Pinpoint Test F: DTCs B1317/B1318 - Battery Voltage High/Low
- Pinpoint Test G: DTCs C1145, C1155, C1165 and C1175 - Wheel Speed Sensor Input Circuit Failure
- Pinpoint Test H: DTCs C1141, C1142, C1143, C1144, C1222, C1233, C1234, C1235 and C1236 - Wheel Speed Sensor Tone Ring Tooth Missing Fault/Wheel Speed Input Signal Missing
- Pinpoint Test I: DTCs C2768, C2769, C2778, C2783, C1305, U1901 and U2527 - Sensor Cluster Fault
- Pinpoint Test M: DTCs C1187, C1188, C1189, C1327 and C1523 - Brake Fluid Level Sensor Circuit Fault
- Pinpoint Test N: DTCs C1322, C1323, C1324 and C1325 - Brake Hydraulic Master Cylinder Piston Travel Sensor Circuit Fault/Failure
- Pinpoint Test O: DTC C1526 - Brake Pedal Travel Sensor Fault
- Anti-Lock Control
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.