Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 940 (INTERIOR LIGHTING SYSTEM)DIAGNOSTIC TESTSINTERIOR LIGHTINGSYMPTOM CHART

2009 Ford Fusion SEL, 3.0 1, FWD

Symptom Chart

2009 Ford Fusion SEL, 3.0 1, FWDSECTION Symptom Chart

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Symptom Chart

Condition	Possible Sources	Action
The interior lamps are inoperative	Fuse Circuitry Smart junction box (SJB)	Go to Pinpoint Test A .
The interior lamps stay on continuously	Circuitry Door ajar switch (integral to door latch) SJB	Go to Pinpoint Test B .
The interior lamps do not turn on with one door open	Circuitry Door ajar switch (integral to door latch) SJB	Go to Pinpoint Test C .
An individual demand lamp is inoperative	Circuitry Lamp assembly	Go to Pinpoint Test D .
An individual interior lamp is inoperative	Circuitry Lamp assembly	Go to Pinpoint Test E .
The illuminated entry is inoperative when using the remote keyless entry (RKE) transmitter/keypad	RKE system SJB	Go to Pinpoint Test F .
The battery saver does not deactivate after time-out	SJB	INSTALL a new SJB. REFER to MULTIFUNCTION ELECTRONIC MODULES article. TEST the system for normal operation.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.