Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 727 (INSTRUMENT PANEL AND CONSOLE)REMOVAL AND INSTALLATIONCONSOLE - OVERHEADREMOVAL AND INSTALLATION
2009 Ford Fusion SEL, 3.0 1, FWD
Removal And Installation
2009 Ford Fusion SEL, 3.0 1, FWDSECTION Removal And Installation
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If removing the track assembly, remove the headliner. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION
article.
- Depress the side tabs and remove the overhead storage bin.
- Remove the overhead console.
- Disconnect the 2 overhead console electrical connectors.
- Remove the dome lamp assembly.
- Disconnect the dome lamp electrical connector.
- To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.