SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 559 (EXTERIOR LIGHTING SYSTEM)GENERAL PROCEDURESFRONT FOG LAMP ADJUSTMENT
2009 Ford Fusion SEL, 3.0 1, FWD

Front Fog Lamp Adjustment

2009 Ford Fusion SEL, 3.0 1, FWDSECTION Front Fog Lamp Adjustment
WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Horizontal aim is not required for this vehicle and is not adjustable. Consult your state vehicle inspection center for recommended tolerance ranges for visual aiming.
  1. Before starting the fog lamp assembly adjustment:
    • check the tire inflation.
    • make sure there are no other loads in the vehicle other than a half tank of fuel.
    • make sure the vehicle is on level ground.
    • make sure the fog lamps and headlamps are clean.
    • make sure the headlamps are operating and are correctly aimed.
    2. NOTE: The vertical wall screen must be a minimum of 2.4-m (8-ft) wide.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.