Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Restraints Control Module (RCM): Installation
2009 Ford Fusion SEL, 3.0 1, FWDSECTION Installation
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
- Position the RCM and install the 2 RCM bolts on the RH side.
- Tighten to 12 Nm (9 lb-ft).
- Connect the small RCM electrical connector.
- Install the RCM bolt on the LH side.
- Tighten to 12 Nm (9 lb-ft).
- Make sure the connector position assurance lever is all the way back and in the full release position before attempting to connect the connector.
All vehicles
WARNING:
The tightening torque of the air bag RCM retaining bolts is critical for correct system operation.
CAUTION:
Putting the large RCM electrical connector into the RCM on an angle can cause bad electrical connections and damage components.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.