Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 266 (AUTOMATIC TRANSMISSION)ASSEMBLYTRANSMISSION
2009 Ford Fusion SEL, 3.0 1, FWD
Section 266 (Automatic Transmission): Assembly: Transmission
2009 Ford Fusion SEL, 3.0 1, FWDSECTION Transmission
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL DESCRIPTION
| Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) |
|
| Rubber Tip Air Nozzle 100-D009 (D93L-7000-A) |
|
| Alignment Gauge, TR Sensor 307-351 (T97L-70010-A) |
|
| Slide Hammer 100-001 (T50T-100-A) |
|
| Installer, Shift Shaft Fluid Seal 307-050 (T74P-77498-A) |
|
| Shim Selection Gauge 307-072 (T80L-77003-A) |
|
| Installer, Servo Piston 307-073 (T80L-77030-A) |
|
| Remover/Installer, Transmission Extension Housing 307-077 (T80L-77110-A) |
|
| Handle, Torque Converter 307-091 (T81P-7902-C) |
|
| Test Plate Screw Set, Transmission 307-126 (T82P-7006-C) |
|
| Air Test Plate, Transmission 307-246 (T92P-7006-A) |
|
| Remover/Installer, Servo Piston 307-251 (T92P-70023-A) |
|
| Installer, Transmission Extension Housing Fluid Seal 308-002 (T61L-7657-A) |
|
| Gauge, Transmission Solenoid Connectors 307-426 |
MATERIAL DESCRIPTION
| Item | Specification |
|---|---|
| MERCON® V Automatic Transmission Fluid XT-5-QM |
MERCON® V |
| Multi-Purpose Grease XG-4 and/or XL-5 |
ESB-M1C93-B |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.