Audio Unit Part Number Retrieval

2009 Ford Fusion SEL, 3.0 1, FWDSECTION Audio Unit Part Number Retrieval
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the audio system on.
  2. Press and hold preset buttons 3 and 6 for 3 seconds. The speaker walk-around test will begin.
  3. Before the speaker walk-around test is complete, press preset button 6.
  4. Press the TUNE UP button. This will either directly indicate the part number or it will cause the audio unit to scroll through config 1, config 2, EEPROM, and the part number information.
    • If the audio unit scrolls through the information, Step 4 may need to be repeated until the audio unit part number can be recorded.
  5. Record the audio unit part number.
  6. Turn the audio system off.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.