Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1656 (INTERIOR LIGHTING SYSTEM)DIAGNOSIS AND TESTINGINTERIOR LIGHTINGINSPECTION AND VERIFICATION
2009 Ford Fusion SEL, 3.0 1, FWD
Inspection and Verification
2009 Ford Fusion SEL, 3.0 1, FWDSECTION Inspection and Verification
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the customer concern.
- Visually inspect for obvious signs of electrical damage.VISUAL INSPECTION CHART
Electrical - Smart Junction Box (SJB) fuse(s):
- 9 (15A) (courtesy lamps)
- 25 (10A) (demand lamps)
- SJB
- Wiring, terminals or connectors
- Bulb(s)
- Interior lamp(s)
- Cargo lamp
- Vanity lamps
- Instrument panel dimmer switch
- Ambient lighting switch (if equipped)
- Smart Junction Box (SJB) fuse(s):
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).
- If the scan tool does not communicate with the VCM:
- Check the VCM connection to the vehicle.
- Check the scan tool connection to the VCM .
- Refer to PINPOINT TEST W: NO POWER TO THE SCAN TOOL , No Power To The Scan Tool, to diagnose no power to the scan tool.
- If the scan tool does not communicate with the vehicle:
- Verify the ignition key is in the ON position.
- Verify the scan tool operation with a known good vehicle.
- Refer to PINPOINT TEST A: THE PCM DOES NOT RESPOND TO THE SCAN TOOL to diagnose no response from the PCM.
- Carry out the network test.
- If the scan tool responds with no communication for one or more modules, refer to DIAGNOSIS AND TESTING .
- If the network test passes, retrieve and record the continuous memory DTCs.
- Clear the continuous DTCs and carry out the self-test diagnostics for the SJB .
- If the DTCs retrieved are related to the concern, go to DTC CHARTS . For all other DTCs, refer to the Diagnostic Trouble Code (DTC) Chart in DIAGNOSTIC TROUBLE CODE (DTC) CHART .
- If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .
NOTE:
Make sure to use the latest scan tool software release.
NOTE:
The Vehicle Communication Module (VCM) LED prove-out confirms power and ground from the DLC
are provided to the VCM
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.