Driver Door Module (DDM) DTC Table

2009 Ford Fusion SEL, 3.0 1, FWDSECTION Driver Door Module (DDM) DTC Table
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
DRIVER DOOR MODULE (DDM) DTC TABLE

DTC Description Retrieved Action
B1342 ECUΒ  is Faulted On-Demand and Continuous INSTALL a new Driver Door Module (DDM). REFER to MULTIFUNCTION ELECTRONIC MODULES .
B1534 Memory 1 Switch Circuit Short to Ground On-Demand and Continuous Go To PINPOINT TEST MΒ .
B1538 Memory 2 Switch Circuit Short to Ground On-Demand and Continuous Go To PINPOINT TEST MΒ .
All Other DTCs - On-Demand and Continuous REFER to the Master DTC Table in MULTIFUNCTION ELECTRONIC MODULES .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.