Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 144 (ENGINE)IN-VEHICLE REPAIROIL PRESSURE SENDERREMOVAL AND INSTALLATION
2009 Ford Fusion SEL, 3.0 1, FWD
Removal and Installation
2009 Ford Fusion SEL, 3.0 1, FWDSECTION Removal and Installation
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove cooling fan motor and shroud. For additional information, refer to ENGINE COOLING .
- Remove the lower radiator splash shield.
- Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE .
- Disconnect the A/C compressor electrical connector and wiring harness retainer.
- Remove the 2 bolts, 2 nuts and position the A/C compressor aside.
- To install, tighten to 25 Nm (18 lb-ft).
- Remove the 6 bolts and position the A/C compressor bracket aside.
- To install, tighten to 25 Nm (18 lb-ft).
- Disconnect the oil pressure sender electrical connector.
- Remove the oil pressure sender.
- To install, tighten to 14 Nm (10 lb-ft).
- To install, reverse the removal procedure.
- Apply pipe sealant with Teflon® to the oil pressure sender threads.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.