Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1337 (BODY PANEL SYSTEM - UNI-BODY SYSTEM, SUBFRAME SYSTEM & MOUNTING SYSTEM)SPECIFICATIONSTORQUE SPECIFICATIONS
2009 Ford Fusion SEL, 3.0 1, FWD
Torque Specifications
2009 Ford Fusion SEL, 3.0 1, FWDSECTION Torque Specifications
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| A/C line bracket nut | 7 | - | 62 |
| Crossmember brace nuts | 48 | 35 | - |
| Engine insulator nuts | 55 | 41 | - |
| Front crossmember nuts | 115 | 85 | - |
| Front stabilizer bar bracket nuts | 70 | 52 | - |
| Front subframe bolts (rear) | 115 | 85 | - |
| Front subframe nuts (front) | 115 | 85 | - |
| Lower ball joint nuts and bolts | 103 | 76 | - |
| Lower steering column shaft coupling bolt | 25 | 18 | - |
| Power steering bracket bolt | 47 | 35 | - |
| Power steering line support bracket bolt | 11 | 8 | - |
| Rear support brace bolts (convertible) | 63 | 46 | - |
| Rear support brace bolts (upper) (convertible) | 25 | 18 | - |
| Steering gear bolts | 115 | 85 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.