Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1332 (AUTOMATIC TRANSMISSION)SPECIFICATIONSBAND/CLUTCH APPLICATION CHART B
2009 Ford Fusion SEL, 3.0 1, FWD
Band/Clutch Application Chart B
2009 Ford Fusion SEL, 3.0 1, FWDSECTION Band/Clutch Application Chart B
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
BAND/CLUTCH APPLICATION CHART B
| Β | Direct One-Way Clutch | Low One-Way Clutch | Engine Braking | ||
|---|---|---|---|---|---|
| Drive | Coast | Drive | Coast | ||
| Reverse | Ha | NEb | NEb | NEb | NO |
| 1st | Ha | NEb | Ha | NEb | NO |
| 2nd | ORc | ORc | Ha | NEb | NO |
| 3rd | Ha | NEb | ORc | ORc | NO |
| 4th | Ha | NEb | ORc | ORc | NO |
| 5th | ORc | ORc | ORc | ORc | YES |
| 1std | Ha | NEb | Ha | NEb | YES |
| 2ndd | ORc | ORc | Ha | NEb | YES |
| 3rdd | Ha | NEb | ORc | ORc | YES |
| 4thd | Ha | NEb | ORc | ORc | YES |
| Manual 3rd | Ha | NEb | ORc | ORc | YES |
| Manual 2nd | ORc | ORc | Ha | NEb | YES |
| Manual 1st | Ha | NEb | Ha | NEb | YES |
a H = Hold
b NE = No effect
c OR = Overrunning
d D Position (overdrive cancelled)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.