Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1328 (INSTRUMENT PANEL & CONSOLE)REMOVAL AND INSTALLATIONPOWER POINTREMOVAL
2009 Ford Fusion SEL, 3.0 1, FWD
Power Point: Removal
2009 Ford Fusion SEL, 3.0 1, FWDSECTION Removal
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Power point cover may differ depending on location.
- Open the power point cover.
- Install the Power Point Socket Remover in one of the power point socket slots.
- Position the Power Point Socket Remover so that it engages in the adjacent slot.
- Using the Power Point Socket Remover, pull the power point socket out of the retainer.
- Disconnect the electrical connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.