Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Audio Systems Without Navigation
2009 Ford Fusion SEL, 3.0 1, FWDSECTION Audio Systems Without Navigation
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The terms "Audio Control Module (ACM)" and "audio unit" refer to the same component.
- Turn the ACM on.
- Press and hold preset buttons 3 and 6 for 3 seconds. The speaker walk-around test will begin.
- Before the speaker walk-around test is complete, press preset button 6.
- Press the TUNE UP button.
- Record the ACM part number.
- Turn the ACM off.
NOTE:
This step will cause the ACM to auto-scroll through configuration 1, configuration 2, EEPROM number, and ACM part number.
NOTE:
Step 4 may need to be repeated until the ACM part number can be recorded.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.