Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1302 (STARTING SYSTEM)SPECIFICATIONSGENERAL SPECIFICATIONS
2009 Ford Fusion SEL, 3.0 1, FWD
General Specifications
2009 Ford Fusion SEL, 3.0 1, FWDSECTION General Specifications
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Maximum starting circuit voltage drop (engine at normal engine temperature) | 0.5 volt |
| Normal engine cranking speed RPM | 100-140 RPM |
| Starter motor no load current draw amperes | 60-80 amps |
| Starter motor normal load current draw | 130 amps |
| Starter motor maximum load current draw amperes | 400 amps |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.