Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1250 (AUTOMATIC TRANSMISSION COOLING SYSTEM)SPECIFICATIONSTORQUE SPECIFICATIONS
2009 Ford Fusion SEL, 3.0 1, FWD
Torque Specifications
2009 Ford Fusion SEL, 3.0 1, FWDSECTION Torque Specifications
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Battery cable | 12 | 9 | - |
| Ground cable | 20 | 15 | - |
| Oil-to-air (OTA) auxiliary transmission fluid cooler bolts | 8 | - | 71 |
| Solenoid wire | 6 | - | 53 |
| Transmission fluid cooler inlet/outlet tube-to-case banjo fittings (TorqShift®) | 40 | 30 | - |
| Transmission fluid cooler tube bracket-to-engine nut (diesel) | 11 | 8 | - |
| Transmission fluid cooler tube bracket-to-engine stud nut (gas) | 12 | 9 | - |
| Transmission fluid cooler tube fitting (4R70E/4R75E) | 27 | 20 | - |
| Transmission fluid cooler tube rear bracket (diesel) | 48 | 35 | - |
| Transmission fluid cooler tube-to-case fitting (TorqShift®) | 52 | 38 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.