Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1155 (REAR DISC BRAKE SYSTEM)REMOVAL AND INSTALLATIONREAR DISC BRAKE SYSTEM - EXPLODED VIEW
2009 Ford Fusion SEL, 3.0 1, FWD
Rear Disc Brake System - Exploded View
2009 Ford Fusion SEL, 3.0 1, FWDSECTION Rear Disc Brake System - Exploded View
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | - | Brake caliper guide bolts (2 required) (part of kit 2C150) |
| 2 | 2553 RH/ 2552 LH | Brake caliper |
| 3 | 2200 | Brake pads |
| 4 | 2C026 | Brake disc |
| 5 | - | Brake caliper guide bolt bushings (2 required) (part of kit 2C150) |
| 6 | 385116 | Brake flexible hose flow bolt |
| 7 | 2179 | Copper washers (2 required) |
| 8 | W500220 | Brake flexible hose bracket bolt |
| 9 | - | Brake line fitting nut |
| 10 | 2B223 | Brake flexible hose retaining clip |
| 11 | 2C338 RH/ 2C339 LH | Brake flexible hose |
| 12 | - | Bleeder screw cap (part of kit 2208) |
| 13 | - | Bleeder screw (part of kit 2208) |
- For additional information, refer to the procedures in this article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.